News

Regular Inspection Of Full Complement Cylindrical Roller Bearings Without Outer Ring

Time:2020.04.10  Source:Roller Bearings Suppliers


Full complement cylindrical roller bearings are designed to withstand heavy loads. At the same width, this type of bearing has a very high load-bearing capacity compared with the traditional type of bearing with a cage. The radial cross-section is small, which can save space, but the speed is relatively low. Need bearing 22234CC/W33, click here.

WSBC RSL182206.jpg

Regular inspection of full complement cylindrical roller bearings is very important to maintain the full condition of full complement cylindrical roller bearings without outer rings, and problems can also be discovered.

Matters needing attention and related knowledge about the use of bearings


Keep full complement cylindrical roller bearings lubricated and clean

Therefore, when we inspect the full complement cylindrical roller bearing, we should first clean the surface of the bearing and then disassemble the parts around the bearing. Everyone should pay attention that the oil seal is a very fragile part, so you need to be extra careful when inspecting and disassembling. Do not apply excessive force to avoid damage to the parts. Then carefully check the oil seal of the bearing and its surrounding parts. If it has already exhibited bad symptoms, it must be replaced. The bad oil seal will cause damage to the bearing and make the bearing cloud shape abnormal and cause the equipment to stop.


Check the lubricant of full complement cylindrical roller bearings

Lubrication is very important, not for full complement cylindrical roller bearings, but also for all bearings. But please note that the bearing should not add too much grease.


Cleaning of full complement cylindrical roller bearings without outer ring

Commonly used gasoline and kerosene as common cleaning agents. When disassembling the bearing for maintenance, first record the appearance of the full cylindrical roller bearing, confirm the residual amount of lubricant, and then start to wash the bearing after sampling the lubricant for inspection. The cleaning is divided into coarse cleaning and fine cleaning, and they are placed in the container separately, and the bottom of the metal mesh pad is placed first so that the bearing does not directly contact the dirt of the container.


Rough cleaning

Use a brush to remove grease and adhesions, and after cleaning, transfer to fine washing. If the full complement cylindrical roller bearing is rotated with dirt, it will damage the rolling surface of the bearing, and care should be taken.


Fine wash

The full complement cylindrical roller bearings are carefully cleaned while rotating in the cleaning oil. In addition, the cleaning oil should also be kept clean. Need bearing 22234CCK/W33, click here.

WSBC RSL182210.jpg

Overhaul and judgment of full complement cylindrical roller bearings without outer ring

In order to judge whether the dismantled bearing can be used, it should be checked after the cylindrical roller bearing without outer ring is fully cleaned.


TEL:+86 0510-83220817

Mail:sales@spark-bearing.com

Add:TIANYI BUILDING,HUISHAN DISTRICT ,WUXI CITY

Copyright © Wuxi Spark Bearings Co.,Ltd Co., Ltd All Rights Reserved. Sitemap
www.spark-bearing.com. Profession in Roller Bearings, Ball Bearings and Taper Toller Bearings-China Suppliers.